Is the LCD on your Blackberry Pearl 8100 series broken? Did you get your Pearl 8120 wet and the back light no longer works? Is it hard to see the Blackberry Pearl LCD screen due to the crack in the LCD?
If you answered yes to any of these questions then this how to repair guide is for you.
To do this repair you will need a T6 torx screwdriver and a guitar pick (or any other small flat tip pry tool).
1. Turn off phone and remove battery.
2. Put the BlackBerry Pearl LCD side down.
3. Pry up lower bottom cover and lift gently towards the front side of the Pearl. There are 4 latches (2 in back, 2 in front) so be gentle. Refer to pictures below.
4. Remove the 2 screws on the bottom front of the Blackberry.
5. Remove the 2 screws on the backside near the top.
6. Remove the 2 sides pieces as shown below. Once both side pieces are removed, you will have access to the clips that hold the top and bottom cover together on the Blackberry Pearl.
7. Loosen the 4 clips on the sides using the guitar pick. See photo below for location of clips.
8. Lift off the back cover. 
9. Flip phone over and remove front cover by lifting it up. As you can see, this exposes the blackberry pearl LCD screen.
9. Flip phone over and remove front cover by lifting it up. As you can see, this exposes the blackberry pearl LCD screen.
10. Run the pick around the edge of the LCD screen to loosen it from adhesive holding it down.
11. Find the connector at the top of the LCD and flip the retaining latch up to release the cable.
12. Remove the cable from the connector, lift and tilt the LCD up from the main board.
12. Remove the cable from the connector, lift and tilt the LCD up from the main board.
13. Install new LCD on the main board. Align new screen and make sure posts slide into position as shown in picture below.
14. Slide LCD cable into the connector and clamp down by pressing black latch down.
Note: Make sure that cable is seated firmly into connector. Failure to do so can cause display problems.
15. Install top cover back on the main board.
16. Install bottom cover back on.
17. Press the two covers together firmly. Make sure the 4 latches snap back down.
18. Install the side covers back on.
19. Install the screws on the backside near the top. Removed in step 5.
20. Install the screws on the front side near the bottom. Removed in Step 4.
21. Install the lower cover removed in step 3. Make sure it is firmly seated and latched down.
22. Install battery and back cover
23. Power on and test.
Enjoy your Blackberry Pearl LCD screen in all its freshly repaired glory.
If you have a white screen or the display is not functioning right, go back to step 14 and make sure the cable is seated fully into the connector.
Enjoy the new Blackberry Pearl LCD Screen!
Disclaimer: Disassembling your Blackberry Pearl 8100 Series Phone will void the warranty. Proceed with the following instructions at you own risk.
is not liable for any damage that may occur. This website is in no way related to or associated with Blackberry or any Mobile Carrier.
Disclaimer: Disassembling your Cell Phone will void the warranty. Proceed with the following instructions at you own risk. http://www.crackedlcdrepair.com/ is not liable for any damage that may occur. This website and any information displayed on this website, contains restricted and/or privileged information and is intended only for authorized screening and/or confidential presentation at the author's discretion. If you are not the owner of this website, you must not disseminate, modify, copy/plagiarize or take action in reliance upon it, unless permitted by the author of this website. This website is in no way related to or associated with T-mobile, Nokia, Samsung, Motorola, Sharp, HTC, ATT, Verizon or Danger Inc
0 commentaires: